Binding tape vs. piping
Binding tape wraps and covers a raw edge. Piping encloses a cord inside a fabric strip and adds a raised edge detail. They use different constructions; specify the intended profile in the drawing or sample.
BAG-MAKING PROCESS · EDGE FINISH
Captions are available in English and Simplified Chinese.
Edge binding covers a raw panel edge with folded tape and stitching. Keep the tape aligned through curves and corners, then confirm coverage and appearance on the approved sample.
This is a general close-up demonstration, not footage of Yunshengyuan’s factory or a record of a specific order. The method and materials vary by bag design.
The clip shows folded binding tape being guided over a fabric edge and sewn. It does not establish a specific tape material, width, stitch setting, machine specification or finished-bag performance.
Confirm tape material, colour, visible width and fold with the outer panel and sample. There is no universal width for every bag.
Fold the tape evenly around the panel edge so the raw edge stays covered. Keep the panel and tape aligned as they enter the guide.
Position the stitch to secure both tape layers and the panel. The exact stitch and needle depend on the material stack and sample.
Feed the tape without twisting or stretching it. At turns, check that the inside edge is covered and the outside edge lies flat.
Look for missed edges, puckering, uneven width, loose threads and inconsistent stitch placement. Compare with the approved sample.
Binding tape wraps and covers a raw edge. Piping encloses a cord inside a fabric strip and adds a raised edge detail. They use different constructions; specify the intended profile in the drawing or sample.
Share the panel or edge to be finished, a drawing or reference sample, tape material and colour, desired visible width, corner shape and any nearby lining or padding. Confirm the final appearance on a sample before bulk production.
It is a finishing method that wraps a fabric tape around a raw panel edge and stitches it in place. Tape material, width and stitch position depend on the bag construction and should be confirmed on a sample.
No. Binding covers an edge with tape. Piping encloses a cord in a strip and creates a raised edge. A design may use either method, so show the required profile on the reference or sample.
Check that the tape fully covers the raw edge, lies flat on both sides and follows the corner without gaps, puckers or twists. Compare width and stitch placement with the approved sample.
Check that the binding covers the raw edge evenly, follows the intended stitch path, and turns cleanly at corners. Confirm tape width, material and color on the actual sample.
Share the bag material, edge shape, target appearance and a reference if available. Confirm tape compatibility, width and color on a sample before approving bulk production.